Picoclick-C3
  • Introduction
  • Hardware
  • Extension Port
  • Software
    • Important note
    • Get battery voltage
    • Serial output
    • ESP-NOW
  • Extension Boards
    • Motion sensor
    • Distance sensor
    • PIR sensor
    • Light sensor
    • GPIO expander
    • Encoder
    • OLED 0.49"
    • OLED 0.69"
  • Enclosure
Powered by GitBook
On this page
  • Hardware
  • Overview
  • Technical drawing
  • Schematics
  • Software
  1. Extension Boards

OLED 0.69"

PreviousOLED 0.49"NextEnclosure

Last updated 2 years ago

The OLED 0.69" extension board is based on the SSD1306 0.69" 14pin OLED display with 96x16 pixels. The display uses I2C to communicate with the Picoclick (SDA = GPIO2, SCL = GPIO8). It uses the 3.3V power supply of the Picoclick and thus is only active when the Picoclick is activated.

The extension connector is underneath the display.

Hardware

Overview

3D model of the OLED display missing but the silkscreen on the PCB shows the border of it.

Technical drawing

  • PCB: 29mm x 10mm

  • Thickness: 1mm

  • Corner radius: 2mm

Schematics

Software

Coming soon.