Picoclick-C3
  • Introduction
  • Hardware
  • Extension Port
  • Software
    • Important note
    • Get battery voltage
    • Serial output
    • ESP-NOW
  • Extension Boards
    • Motion sensor
    • Distance sensor
    • PIR sensor
    • Light sensor
    • GPIO expander
    • Encoder
    • OLED 0.49"
    • OLED 0.69"
  • Enclosure
Powered by GitBook
On this page
  • Hardware
  • Overview
  • Technical drawing
  • Schematics
  • Software
  1. Extension Boards

Encoder

PreviousGPIO expanderNextOLED 0.49"

Last updated 2 years ago

The encoder extension board is based on the EC11 SMD encoder with integrated button. The output pins of the encoder are connected to GPIO2 and GPIO8. The button of the encoder can be used to activate the Picoclick.

Hardware

Overview

Technical drawing

  • PCB: 18mm x 23mm

  • Thickness: 1mm

  • Mounting holes: 3.2mm

  • Corner radius: 2mm

Schematics

Software

Measurements in mm, grid is 0.5mm